Lost connection MX10 with Windigipet 2025
Verfasst: 17 Aug 2025, 12:10
Hello Forum , I am a new Bee , and i need help implementing the Zimo MX 10 in Windigipet 2025.
When Windigipet 2025 is activated, the blue screen of the Zimo MX10 clearly shows the LAN connection "Windigipet."
I can control all turnouts with their own DCC address.
However, as soon as I want to Use a Locomotive , and use a driving function or other function in a locomotive screen, the connection is lost.
See Abbruchcode 6
According to the Zimo manual for the MX33FU, page 32 "External and computer control", I should see a warning message on the MX33FU hand controller for the active locomotive that the locomotive is under "external control."
This is not the case. When I operate the speed controller of the locomotive window from WindiGipet, the connection get also lost.
see Abbruchcode 2
Are there any settings I have forgotten?
Zimo firmware used: MX10_MX33_2025-06-26.
Regards
Rupert
When Windigipet 2025 is activated, the blue screen of the Zimo MX10 clearly shows the LAN connection "Windigipet."
I can control all turnouts with their own DCC address.
However, as soon as I want to Use a Locomotive , and use a driving function or other function in a locomotive screen, the connection is lost.
See Abbruchcode 6
- Abbruchcode 6.jpg (227.08 KiB) 2840 mal betrachtet
This is not the case. When I operate the speed controller of the locomotive window from WindiGipet, the connection get also lost.
see Abbruchcode 2
- Abbruchcode 02.jpg (152.02 KiB) 2840 mal betrachtet
- Fehler bei verbindung .jpg (325.25 KiB) 2840 mal betrachtet
Zimo firmware used: MX10_MX33_2025-06-26.
Regards
Rupert