Lost connection MX10 with Windigipet 2025

[Rupert van Swol]

Hello Forum , I am a new Bee , and i need help implementing the Zimo MX 10 in Windigipet 2025.
When Windigipet 2025 is activated, the blue screen of the Zimo MX10 clearly shows the LAN connection "Windigipet."
I can control all turnouts with their own DCC address.

However, as soon as I want to Use a Locomotive , and use a driving function or other function in a locomotive screen, the connection is lost.
See Abbruchcode 6

Abbruchcode 6.jpg (227.08 KiB) 2838 mal betrachtet

According to the Zimo manual for the MX33FU, page 32 "External and computer control", I should see a warning message on the MX33FU hand controller for the active locomotive that the locomotive is under "external control."
This is not the case. When I operate the speed controller of the locomotive window from WindiGipet, the connection get also lost.
see Abbruchcode 2

Abbruchcode 02.jpg (152.02 KiB) 2838 mal betrachtet

Fehler bei verbindung .jpg (325.25 KiB) 2838 mal betrachtet

Are there any settings I have forgotten?

Zimo firmware used: MX10_MX33_2025-06-26.


Regards

Rupert

[ZimoGuru]

Hi Rupert!

Sorry, but I don`t have any experience with Windigipet.
Please contact ZOMO and/or Windigipet dirctly.